Chto-013bb manual

 · The CHTOBB has a 4-channel input, meaning you will keep your fade control with the factory amp and an aftermarket stereo. When the install was all finished, the steering wheel's voice command button did not work with the Kenwood stereo; all other audio buttons worked, and he had volume up/down, track forward/back, change source, and seek forward. • Plug the pin harness into the CHTO The pin harness (ASWC plug) will be discussed later in the manual. Page 5: Audio Level Control 1. Make sure the ignition is turned to the “off” position. 2. Disconnect both of the harnesses from the CHTO 3. Locate the potentiometer next to the pin connector at the end of the CHTO 4.  · DESCRIPTION. The Metra CHTO is designed to allow the user to replace the OEM radio with an aftermarket unit in select Chrysler/Dodge/Jeep vehicles with the amplified sound system and will retain the use of the OEM amplifier. The amplifier receives a digital signal from the radio to turn on and off instead of the normal 12 volt 5/5(4).

Connect the pin harness, and the CHTO harness, to the CHTO interface. 2. Connect the CHTO harness to the wiring harness in the vehicle. 1. Cycle the ignition on and wait until the radio comes on. Note: If the radio doesn’t come on within 60 seconds, cycle the key off, then unplug the interface. The CHTO sends that digital signal to the amplifier to tell it to turn on and off. The CHTO is packaged with both Chrysler CAN vehicle wiring harnesses to give the CHTO a broader application range. Also the CHTO is up datable by using the USB-CAB, the USB update cable, and the Axxess web site, to help eliminate inventory that is. Instruction Manual; Product Information Sheet; Applications below use the LD-CHTO harness: CHRYSLER. ; Aspen ; PT Cruiser ; DODGE.

E5CC/E5EC Digital Temperature Controllers Communications Manual . E5CC/E5EC) ( , , () Для сигнализации о том, что выполнен вход на. CHTO Chrysler Data Interface Up. USA MSRP: $ USD. Product Features; Tech Docs Instructions; Vehicle Applications. энергосбережения по умолчанию настроена таким образом, что флагов для всех выполняемых по фронту команд (DIFU(), команды с префиксом @, DIFD() и.